flir LOREX LNZ32P4 Manual De Instrucciones página 12

4 Installation
4. Align the 3 mounting holes on the dome camera base with the 3 corresponding
mounting holes on the wall mounting bracket.
NOTE
Ensure that the cable notch on the dome camera base is aligned with the cable notch on the wall
mounting bracket.
1: Mounting Holes
5. Use the Hex Bolt M4x10 (x3) screws included with the wall mounting bracket kit to
secure the position of the dome camera base.
6. Holding the flat side of the back plate against the mounting surface, mark holes for the
mounting screws ST4 (x4) and the camera cable. Remove the back plate and drill
where marked.
NOTE
You do not need to mark holes for the camera cable if you plan to run it along the wall / ceiling.
1: Mounting screw ST4 (x4) holes, 2: Camera cable hole
#LX400075; r.34407/34407; en-US
9