Medisana 88365 Instrucciones De Manejo página 20

GB
3 Operating
3.4
Function
setting
3.5
Aromatic
substances
14
Sit down comfortably in front of the foot spray bath and select one of the three
different functions using the Rotary switch
Heat function selection
The MEDISANA WBM foot spray bath includes an innovative heating
function. This technical improvement makes it possible to keep the water at a
constant temperature during application or to warm it.
Position 1 : Maintain the water temperature
If you have switched the Rotary switch to 1, the temperature of the filled water
will remain – or it will be heated a little.
Position 2 and 3 : Heating water
If set to position 2 or 3, a warming function is turned on automatically.
Tap water reaches a pleasant temperature for a relaxed footbath after ca. 10
minutes and this is kept constant during application.
If the water in position 2 or 3 is heated too hot for you, turn down to position
1 and wait until the water has cooled down to the temperature you desire. If
you add cold water to lower the temperature, please make sure not to exceed
the maximum filling height
WARNING
If you are very sensitive to heat, have cardiovascular problems,
swellings, inflammations, skin irritation or skin wounds, please
consult your doctor before use.
Remove the cap and place the aromatic substances and bath oils in the depres-
sion located below. During operation of the device, the additive will
slowly be mixed into the water.
.
.