Completing Installation - Dometic BLINDS FlyTec FT 100 Instrucciones De Montaje

FlyTec FT100
Installing the magnetic plate (fig. 9, page 6)
A
NOTICE!
• The adhesion points must be clean, dry and free of grease in order
for the magnetic plate to adhere well to the cover profile.
• Clean the adhesive surface with a suitable cleaner. It may be
necessary to check suitability on a hidden spot.
• Use lint-free cloths.
➤ Glue on the magnetic plate.
5.5

Completing installation

Riveting the cassette profile with the cover profile for the C pillar (fig. 0,
page 7)
➤ Put all the blind rivets (4 x 8 mm with stainless steel mandrel) through the drill
holes and rivet the components using a hand riveter.
Tensioning the guide cables
➤ Tension the guide cables on the deflection screws on the skirting board and the
top guide rail (fig. a, page 7).
The tension of the cables affects the guidance and smooth running of the handle
strip. By changing the tension of the upper and lower cable, you can adjust the
parallel orientation of the handle strip to the magnetic plate.
➤ Secure the safety clips onto the deflection screws each with a screw
(M2.5 x 6 mm) (fig. a 1 and 2, page 7).
EN
Installing the flyscreen
15