Booster PAC Truck Pac ES1224 Manual De Usuario página 5

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Charging using the supplied wall charger (recommended method). This is the
recommended charging method because it features automatic charging, eliminating
the possibility of overcharging. With this method, the wall charger is connected to the
Truck PAC through a small charging jack (pin jack), located on the rear of the unit.
Recharging takes approximately 4 to 6 hours for each light that does not come on
when the Test Button is pressed. With this method, your Truck PAC can be left
connected to the wall charger indefinitely.
1. Insert the wall charger pin into the CHARGING JACK (located in the front of the
Truck PAC).
2. Connect the wall charger AC/DC ADAPTOR to the AC outlet (the yellow
CHARGING light will light). (See Figure 2.)
3. Allow the Truck PAC to charge until the CHARGE COMPLETE light comes on
(you can monitor the progress by checking the red POWER LEVEL lights – after
all three POWER LEVEL lights are lit the CHARGE COMPLETE light should
come on).
4. Once the CHARGE COMPLETE light comes on, charge another three to six
hours (three hours is acceptable, but to ensure maximum output capability, six
hours is preferred).
Note: The CHARGE COMPLETE LED indicates that the charging process is
complete. It may illuminate for a short period after the charger is unplugged
from the unit due to the surface charge, but this will only occur for a short time,
which is normal. To assess the unit's readiness, monitor the Power Level LED's.
5. If you are not planning to use your Truck PAC right away, you may leave it
connected to the wall charger. We recommend that the wall charger remain
connected to the Truck PAC when not in use.
Charging using the supplied 12 Volt Male-Male Extension Cord. This alternative
charging method may be used when access to an AC outlet is unavailable.
1. Start the vehicle's engine.
2. Plug one end of the 12 Volt Male-Male Extension Cord into the Truck PAC
12 Volt outlet and the other end into a vehicle 12 Volt outlet. Set the Voltage
Selector Switch to 12V mode.
3. Press the Test Button once every hour to check the POWER LEVEL. When all
of the red lights come on, charge the Truck PAC another 1 to 2 hours to ensure
a complete recharge.
Note: DO NOT OVERCHARGE! This is not an automatic method of charging
the Truck PAC. You must frequently monitor the charging process to ensure the
unit is not overcharged.
WARNING: Overcharging the Truck PAC when using this charging
method can create explosive gasses which could result in property
damage and personal injury. DO NOT OVERCHARGE!
5

Publicidad

Tabla de contenido
loading

Tabla de contenido