Master BC 180 Manual De Instrucciones página 13

►►6. TROUBLESHOOTING
FUNCTIONING
ANOMALIES
The display doesn't
work
No air flow or too low 1. Obstruction of the air
The device does not
respond to comman-
ds
The device leak
water
Figures and texts of this book are protected by COPYRIGHT.
CAUSES
1. No power supply
2. Defective equipment
intake on the back
2. Defective equipment
1. Defective equipment
1. The drain cap is loose
2. The drain is dirty and the
cap doesn't fit
3. The tank leak
4. The panel drip
SOLUTIONS
1a. Check whether the devi-
ce is connected to power
supply
1b. Contact service point
2. Contact service point
1a. Keep the back side far
from walls that can block
air inlet
1b. Remove objects from
inlet air section
1c. Contact service point
2. Contact service point
1. Contact service point
1. Close the drain cap
2. Clean the drain and close
the cap
3. Contact service point
4. Contact service point
en