Ibiza Light FXBAR140 Manual De Instrucciones página 5

SPECIFICATIONS
Power supply
Consumption
Light source
DMX channels
Dimensions
Weight
TROUBLE-SHOOTING
The unit doesn't work, no
light and no fan
No response to the DMX
controller
Some of the units don't res-
pond to the controller
No response to the sound
Correct Disposal of this product
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To
prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly
to promote the sustainable reuse of material resources. To return your used device, please use the return and collec-
tion systems or contact the retailer where the product was purchased. They can take this product for environmental
safe recycling.
BARRE D'ANIMATION MATRICABLE 2-EN-1
AVEC EFFET BLINDER BLANC CHAUD & ECLAIRAGE
DÉBALLAGE
Dès réception de l'appareil, ouvrez le carton et vérifiez que le contenu est complet et en bon état. Sinon, pré-
venez immédiatement le transporteur et conservez l'emballage s'il montre des signes de mauvais traitements.
Conservez le carton et tous les matériaux d'emballage afin de pouvoir transporter l'appareil en toute sécurité.
CONTENU DE L 'EMBALLAGE:
• 1 FXBAR140
• 1 cordon secteur
• 1 Mode d'emploi
MANUAL - FXBAR140
110-220V~ 50/60Hz
100W
14x 3W warm white CREE LEDs
56x 3-in-1 5050 RGB LEDs
6, 8 12 or 60
1000 x 70 x 100mm
2.66kg
1. Check the connection of power and main fuse
2. Measure the mains voltage on the main connector
3. Check the power on LED
1. DMX LED should be on. If not, check DMX connectors, cables to see if
link properly
2. If the DMX LED is on and no response to the channel, check the address
settings and DMX polarity
3. If you have intermittent DMX signal problems, check the pins on connec-
tors or on PCB of the unit or the previous one.
4. Try to use another DMX controller
5. Check if the DMX cables run near or run alongside to high voltage
cables that may cause damage or interference to DMX interface circuit
1. You may have a break in the DMX cabling, Check the LED for the res-
ponse of the master/slave mode signal
2. Wrong DMX address in the unit, Set the proper address
1. Make sure the unit does not receive DMX signal
2. Check microphone to see if it is good by tapping the microphone
RVB EN ARRIERE-PLAN
NOTICE D'UTILISATION
www.ibiza-light.com
FR
5