Rear Panel Features - Numark NDX 900 Guia De Inicio Rapido

REAR PANEL FEATURES

4
1. POWER IN – Use the included power cable to connect the mixer to a power outlet. While the power is switched off, plug
the power supply into the mixer first, then plug the power supply into a power outlet
2. VOLTAGE SELECTOR – This 2-position switch sets the AC input voltage for the NDX900 Controller. U.S. users should
set this switch to "115V" whereas U.K. and most European users will need to set this to "230V"
3. POWER BUTTON – Press this to turn the unit on and off
4. USB SLAVE – Connect the NDX900 Controller to a computer via this USB jack and your NDX900 Controller can be
used as a software controller device using USB MIDI protocol or as a USB audio device
5. USB AUDIO OUTPUT (RCA)- Sends out a stereo mix of the audio coming from the computer's USB connection to the
NDX900
6. LINE OUTPUT (RCA) – Use standard RCA cables to connect this output to the line input of your mixer
7. DIGITAL OUTPUT – This RCA connector will allow you to send a digital audio signal to any device designed to accept a
S/PDIF (Sony/Phillips Digital Interface Format) signal. You can also connect the digital output to a karaoke decoder to
reproduce the graphics from CD+G discs
8. FADER START – Use this connector to plug into your fader start compatible mixer or remote switch. To use this
connector for fader start, use a fader start cable to connect to a fader start compatible mixer. Every time you move the
crossfader on the mixer to the side that the unit is on, it will start playing. When you move the fader away from that side,
the unit will stop. Moving the fader back will start playback again
9. RELAY – Relay play allows two compatible CD players to alternate play from one unit to the other and back as the
tracks end. To use the relay feature, connect one end of your relay cable here and the other end to the relay jack of
your other CD player. To turn relay mode on and off, hold the MODE button and turn the parameter knob
LCD FEATURES
1. PLAY / PAUSE – This shows when the unit is playing
or paused
2. CUE – Flashing when the unit is setting a cue point. Lit
continuously when the unit is paused at a cue point
3. TRACK NUMBER – Shows the current track number
4. TOTAL TRACKS – Shows the total number of tracks
on the CD
5. MP3 – Indicates when there are MP3s present on the
disc or connected USB device
6. MINUTES – Shows the minutes elapsed or remaining
depending on mode setting
7. SECONDS – Shows the seconds elapsed or remaining depending on mode setting
8. FRAMES – The CD player breaks down a second into 75 frames for accurate cueing. This shows the frames elapsed or
remaining depending on mode
9. TIME MODE – Indicates whether the time shown on the LCD is the elapsed time for the track, remaining time for the
track, or total remaining time for the entire CD
10. BPM – The tempo, which is indicated in BPM (beats per minute)
11. PITCH – Shows the percentage change in pitch
12. KEY LOCK – Indicates when Key Lock Mode is engaged. The number next to the lock icon indicates how far away the
track's current key is from its original key (in semitones)
13. LOOP – Indicates when a loop is programmed. When the indicator is flashing, a loop is currently playing
14. TEXT DISPLAY – Displays folder names, CD information, and MP3 tag information
5 6
7 8 9
1
3 1 2
4
2
13 9 14
4
3
2
6 7 8 10
11
5 9
12