Listening To Your Ipod - iSymphony M110 Manual De Usuario

Dock Adapter Compatibility
30GB
5G with Video
60GB
80GB
1GB
nano
(1st generation)
2GB
4GB
2GB
nano
(2nd generation)
4GB
8GB
20GB
photo
30GB
40GB
60GB
4G 20GB
40GB
4GB
mini
6GB
10GB
3G
15GB
20GB
30GB
40GB
A B C D
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
33
Charging your iPod
Note: Please make sure you are using the correct insert for your iPod and that it is properly docked
into this unit. FAILURE TO DO SO MAY DAMAGE THE iPod .
When an iPod is inserted into the dock, it will go to standby mode then turn off. Whilst the iPod is
docked in the system, it will recharge (until fully charged).

Listening to your iPod

1. Insert the iPod as described above.
X
With the unit turned on, press the function button repeatedly
2.
until "iPod " is shown in the display.
X
Press the PLAY/PAUSE, Stop button on the Micro System to
3.
X
commence, control playback and stop.
X
NOTE: The volume control on the iPod only adjusts the
X
volume of any headphones connected. To increase volume
X
when connected, use the volume controls on the front panel or
remote control.
IMPORTANT: To prevent distortion during iPod playback you should go to the Main Menu of your
iPod, select the Settings Menu page, select the EQ Setting, and make sure that the EQ function is
set to "Off".
Main Menu
PC Connection
A docked iPod can be connected to a PC using the "iPod USB Sync" socket on the rear of the
system. To set up the connection, insert the iPod connector end of the iPod PC cable (supplied with
iPod) to the socket on the rear of the system and connect to the PC USB port. Files can then be
uploaded to the iPod using iTunes.
Settings Menu EQ Setting
30 PIN
CONNECTOR
34
Select "Off"
USB CONNECTOR