Maintenance And Storage - Sunbeam 078505 Manual De Instrucciones

MAINTENANCE AND STORAGE:

NOTE: Any other maintenance not explained in this manual should be
performed by an Authorized Service Center. To store unit, coil and secure cord
and place in original carton.
USING THE ATTACHMENTS:
Plastic combs for attachment to clippers and trimmer blades are included with
some kits. The comb attachment is grooved to fit snugly over the blades. When
attaching the comb to the clipper, slide the comb down firmly as far as it will go.
Make sure the comb is seated securely against the lower blade. To disengage
the comb, pull and slide the comb upward until it is off the clipper. Replacement
combs are not covered under warranty.
ADJUSTABLE CLIPPERS:
After continued use, the top and bottom blades may wear out. Replacement
blades are available through
your nearest Authorized Service
Station.
To remove the blades, unplug the
clipper from the electric outlet. Lay
the unit upside down on a flat, dry
surface. Remove the two screws
located in the bottom of the blade.
To replace blades, put the new top
blade into position on the clipper
head. Make sure the adjustment
lever is pushed downward.
Line up the new bottom blade
so that the screw holes in the
bottom blade are directly over
the two center screw holes in
the mounting plate. Replace the
screws. Before tightening the
screws adjust the position of
the blades so that the top blade
is 1/32" back from and is parallel to the front edge of the bottom blade. The
blades should also be even on each side. Tighten screws firmly.
C
E
F
E3
D
C. Bottom Blade
D. Screw Holes
G
E. Screw Plate
F. Top Blade
G. Screw Holes