Sears Craftsman 247.776350 Manual Del Operador página 6

IMPORTANT:This unit is shipped without gasoline or
oil in the engine, After assembly, see OPERATION
section of this manual for proper fuel and engine oil fill-
up.
This Chipper Shredder has been completely assembled
at the factory, except for the debris collection bag,
which is stowed in the chipper chute for shipping.
Removing Unit From Carton
Remove staples, break glue on top flaps or cut tape
at carton end and peel along top flap to open
carton.
Remove any loose parts.
Cut down along carton edges and lay carton down
flat.
Remove packing material. Lift unit from the rear
and discard bottom pad. Roll unit out of carton.
Check carton thoroughly for loose parts.
Loose Parts In Carton (SeeFigure 1)
One Tamper
One Debris Collection Bag (Not Shown)
One Pair of Safety Glasses (Not Shown)
One 20-oz. Bottle of Engine Oil
One Operator's Manual
20-oz. Bottle
of Engine Oil
Tamper
Figure 1
Lowering the Chipper Chute
WARNING:
Never operate the chipper
shredder without chipper chute lowered into
the operating position.
For shipping reasons, the unit is cartoned with its
chipper chute in a raised position.To pivot it downward,
into the operating position, proceed as follows:
Pull the spring latch upward and gently pivot the
chipper chute down until it clicks into the lock rod.
See Figure 2.
Figure 2
Raising the Chipper Chute
WARNING:
Never operate the chipper
shredder without chipper chute lowered into
the operating position.
For convenience when storing, the chipper chute can
be pivoted upward. To do so, proceed as follows:
Pull the lock rod outward and pivot the chipper
chute upward until it clicks into the spring latch. See
Figure 3.
Latch
Lock Rod"
Figure 3