Sibir A 30-80 K Instrucciones De Manejo página 31

GB
When knob (A) is ineffective or if the temperature is unnecessarily too low:
Turn off unit
Pull out plug from socket.
8. Liquid gas operation
Do not use any additional form of energy (mains/battery). The unit must not be
connected to town or natural gas pipelines. It is only suitable for use with
propane/butane gas (e.g. Calor Gas, Camping Gaz, Caravangas, etc).
The refrigerator is equipped for a specific gas-pressure, corresponding to the
standard pressure of the country in which it is sold. The rating-plate states the
pressure which is correct. It is important that a non adjustable pressure-
regulator is used to reduce the pressure in the gas cylinder to the operating
pressure specified on the rating-plate, no other pressure may be used.
Needle valve operated gas control taps are NOT suitable for use with this
appliance and must not be used as a substitute for a pressure regulator.
9. Connection of gas supply
(The following instructions refer in the main to coolers manufactured for the
United Kingdom. For other countries please refer to your supplier).
Always connect in the following sequence:
→ → → →
GAS BOTTLE PRESSURE-REGULATOR APPLIANCE.
To connect the appliance to the pressure regulator an APPROVED GAS
TUBING should be used. This should be minimum in length-have an inside
dimension of 8mm and be marked BS3212/2/8.
The pressure-regulator must be compatible for Butan 11 in(28mbar) or for
Propane(37mbar).
To connect the pressure-regulator to the gas bottle, the valve of gas bottle must
be closed.After connecting the pressure-regulator to the bottle by
screwing,connect the two ends of the tubing to the nipples and secure them with
the two hose clipse.
When fitting the connection to the gas inlet of the appliance , hold counterpart
to avoid straining and possibly damaging.
The gas bottle must only be used in an upright position and particular care must
be taken every time the appliance is connected to the gas bottle to ensure that
there are no leaks, that the gas pipe (rubber hose) is not under tension or
kinked, and that it is not in contact with hot surfaces.
The connection pipe and gas bottle should always be located in positions where
they will not be tripped over or otherwise inadvertently disturbed.
Before attempting to light the burner, every time after connection, turn on the
gas at the bottle and check the gas connections for leaks by applying a soap
31