Dremel 335 Instrucciones De Funcionamiento Y Seguridad página 5

Euro 335 7-03.qxd.Gesamt 17.11.2003 13:59 Uhr Seite 5
Inserting the Router Bit
The router bits are held in the tool by a
collet system. The bit may be installed be-
fore or after the rotary tool is installed in
the attachment.
1. Depress and hold the shaft lock button
while rotating the collet nut and shaft.
Continue to rotate the collet nut and
shaft until the lock engages and holds
the shaft (Fig. 4).
2. Use the wrench from your Dremel Rotary
Tool and turn the collet nut counter-
clockwise to loosen it.
3. Release the shaft lock button.
Shaft Lock
Button
Collet Nut
GB
4. Insert the router bit into the collet as
deep as possible to ensure proper grip-
ping of the bit and to minimize run out.
Do not insert the bit so far that bit flutes
touch the collet or collet nut to avoid
chipping or cracking the bit.
NOTE: Never place the tool with bit
protruding through base on top of bench
or work surface. Lay the tool on its side
or retract the bit before setting on bench
or work surface. Protruding cutting bit
may cause tool to jump.
5. Re-engage the shaft lock button and
tighten the collet nut; first by hand, then
using the wrench until bit is held securely.
Collet Nut
Base
5
FIG. 4
Wrench