Greenlee 881-MBT Manual De Instrucciones página 5

Assembly (cont'd)
Bender
1. Position shoes, follow bars, saddles, and pump as
shown in Fig. 1 and 2.
Note: Some follow bars are stored on the shelf
behind the shoe.
Pump
Follow
Bar
Shoe
Figure 1
Figure 2
2. Refer to 99980711 (IM 981) to assemble the 881
connecting bars and roller. Place them into the
carrier assembly and pivot into the horizontal
position.
Greenlee Tools, Inc.
Saddle
881-MBT Mobile Bending Table
3. Place the ram in-between the connecting bars as
shown in Fig. 3.
Hose
Ram
Pump
Caster
Locking Arm
4. Assemble the yoke, spring clip, ram positioner, and
pins. Position this assembly as close as possible to
the connecting bar pivot point. Pivot the connecting
bars with ram into the vertical position and lock in
place (Fig. 4).
Note: One of the cylinder block pin units should be
holding the connecting bars together at all times.
5. Attach the 90° coupling to the ram coupling of the
bender. Then connect the pump to the ram, using
the high pressure hose supplied with your bender.
5
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Connecting
Bars
Roller
Lock Plunger
Figure 3
Connecting
Bars
Ram
Spring Clip
Yoke
Figure 4
Carrier
Assembly
Parts
Tray