Bending - Greenlee 881-MBT Manual De Instrucciones

Bending

1. Position and secure the carrier assembly against the
coupling as shown.
2. Install the proper shoe and follow bar for the conduit
size to be bent.
3. Load the conduit into the bender and position for
the bend. Attach the saddle to the shoe.
4. Strap down the other end of the conduit, using
the chain vise on the vise assembly.
Conduit
Vise Assembly
Locate Carrier Assembly
against the coupling
Figure 11
Greenlee Tools, Inc.
Bend
Direction
Follow Bar
as shown
Carrier Assembly
881-MBT Mobile Bending Table
Note:
Always locate the vise assembly as far as
possible from the end of the follow bar, as
shown.
For detailed bending instructions, refer to the instruction
manual for the 881 and 881CT Hydraulic Benders—
publication 99980711 (IM 981).
Shoe
8
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Saddle