Cleaning with the handheld
• Remove the handheld from the lower part of the device by pressing the hand-
held release button (11) and switch the device on using the On/Off button (12). If
required, select the suction mode using the suction mode button on the hand-
held (13).
• Accessories: the cleaning attachments will be inserted into the suction duct of
the handheld for use (see fig.1) and can be attached to the charge station for
safe storage.
6. Cleaning and maintenance
Emptying the dust container
Press the dust container release button (14) to remove the dust container.
Take the filter unit out of the dust container by holding the two fixing brackets and
empty the container into a waste disposal bin (see fig. 2).
Cleaning the filter
Note: Clean the filter regularly to maintain a consistently high cleaning performan-
ce.
Drain the coarse filter (16). If necessary, the transparent casing can be removed by
turning it slightly, the arrow pointing to the open lock (see fig. 3). To clean the dust
filter (15), remove the coarse and dust filters by lightly pressing the tab (see fig. 4).
Beat the dust filter out until the visible dirt is removed (see fig. 5). The filters can be
cleaned under running water. Do not use an additional cleaning agent. Ensure that
the filters are completely dried before the filter unit is replaced (see fig. 2).
Cleaning the brushes
Press the slide switch on the lower side of the floor cleaner head (7) and remove
the fixing of the cleaning brushes (6).
Remove the cleaning brush (8) and dispose of loose dirt. Long hair and fibres can
be easily removed by cutting the fibres by running the cutting gouge of a pair of
scissors along the entire length of the brushes.
Replace the cleaned brushes and the fixing for the brushes and lock them with the
slide switch.
Other cleaning
If necessary, remove the floor cleaner head from the device by pressing the release
button (4) on the floor cleaner head and remove the disruptive objects from the suction duct.
7. Optional accessories
The battery unit can be removed/exchanged with the device. Only use the device with the origi-
nal vacuum batteries from Leifheit!
Removing/exchanging the battery unit
Press the release button battery unit (10) and slide the battery unit (9) from the device. Push the
battery unit into the handheld until it locks before use.
8. Disposal
The battery unit must be removed before disposing of the device. To do this, disconnect the device
from the mains power supply and remove the battery unit from the handheld by pressing the relea-
se slide, and then properly removing the battery unit. The symbol on the product or its packaging
indicates that this product is not to be treated as normal household waste, but rather has to be
given to a collection point for the recycling of electrical and electronic devices. You can find further
information about your municipality, communal disposal businesses or the company from which you
bought the product.
9. Conformity/Declaration of conformity
Leifheit hereby declares that this device is conformant with the basic requirements and the common
relevant provisions of the Directives 2014/30/EU, 2006/95/EG, 2014/35/EU (RoHS) and Regulation
1907/2006/EU (REACh). You can find the EU declaration of conformity at www.leifheit.de.
t
34
Bedienungsanleitung Regulus Powervac.indd 34
1
2
3
4
5
6
02.06.17 07:49