Setting up
5_
Flush 3 gallons of water through
the
filter
before drinking
or using the water
from the refrigerator.
(Flush approximately
6 minutes.)
This will clean the water supply system
and remove air from the lines.
To flush, press the Water button,
and then
press a large glass or cup against the water
dispenser
lever. Fill the glass, empty
it into
the kitchen sink after it is filled, and then
repeat.
NOTE
• Additional
flushing
may be required
in
some households.
6. Open the refrigerator
door and make
sure there are no water leaks coming
from the water filter.
_)
NOTE
• After you turn on the refrigerator,
let the
ice maker make ice for 1 to 2 days.
Over that period of time, throw out the
first
1 or 2 buckets of ice the ice maker
makes to ensure all impurities
have been
removed
from the water line.
• Only connect the water line to a
drinkable
water source.
• If you have to repair or disassemble
the
water line, cut off 1/4" (6.35 mm) of the
plastic tubing
to make sure you get a
snug, leak-free
connection.
• You can test the water line quickly
using
a paper cup. Under normal
conditions,
the water dispenser
can fill a 5.75 oz.
(170 cc) cup in about 10 seconds.
34
English
DA68-02981N-00.indb
34
2015.3.3.
[qrq9:34