Epson ELPLS02 Manual De Instrucciones página 15

2. Mounting the zoom lens (When a lens has been installed)
* In the event that no lens has been installed, please refer to section 3.
• Note that the illustrations below may not match your particular projector
model.
2-1 Remove the current lens
(1) Shift the lens to the centre position and turn off the power.
Memo
1. At the same time, push and hold the Shift and
keys, for at least 5 seconds. The lens shifts itself slowly to the
centre position.
2. Turn off the power and remove the power supply cable.
Remove the power cable before attempting to attach
the lens. Otherwise, there is the risk of an electric shock.
Memo
02_SZL_DTP_E.p65
Be sure to remove the front lens cap before
turning on the power, or it may melt from the
heat.
Warning
Always mount and dismount the lens in a
clean room, to minimize the amount of dust.
Excessive dust inside the lens could cause
damage.
Page 13
Lens Shift
13
03.2.19, 5:39 PM Adobe PageMaker 6.5J/PPC