Adjusting The Level - Samsung RF30KM Serie Manual De Usuario

ADJUSTING THE LEVEL

Make sure the refrigerator is level so that you can
make final adjustments. Use a level to test if the
refrigerator is level both side to side and back to
front. If the refrigerator is not level, you will not
be able to get the doors perfectly even, which
may cause moisture condensation and increased
energy bills. Below is an example of how to level
the refrigerator if the left side of the refrigerator is
lower than the right side.
flat-blade screwdriver (-) Control Lever
How to adjust the level
1. Open the freezer drawer and remove the lower
basket.
2. Insert a flat-blade screwdriver (-) into the notch
on the left control lever, and turn it counter-
clockwise to level the refrigerator. (You turn the
lever clockwise to lower the refrigerator and
counterclockwise to raise it.)
Both control levers must be touching the
floor to avoid possible personal injury or
CAUTION
property damage because of tipping.
If the right side is lower, perform the same
procedure, but with the right control lever.
It is difficult to remove the cover leg
front from the refrigerator, so we do not
recommend making small adjustments
with the control lever. Instead, refer to the
next page for the best way to make minor
adjustments to the doors.
14 English
RF30KMED_DA68-02894B-02_EN.indd 14
MAKING MINOR
ADJUSTMENTS TO THE
DOORS
Remember, a leveled refrigerator is necessary
for getting the doors perfectly even. If you need
help, review the previous section on leveling the
refrigerator.
Fixed part
The left door is fixed. To make minor door
adjustments, adjust only the right door.
1. Pull out the flex door ( 1 ) to reveal the lower
hinge ( 2 ).
2. Insert a philips screwdriver (+) ( 3 ) into the
shaft ( 4 ) of the lower hinge.
3. Adjust the height by turning a philips
screwdriver (+) ( 3 ) clockwise (
UP
counterclockwise (
When you turn a philips screwdriver (+)
counterclockwise (
move up.
2
4
1
3
Adjustment
part
) or
DOWN
).
), the door will
3
2017-05-23 5:14:36