Reverse Osmosis Water Supply; Important - Samsung RF30KM Serie Manual De Usuario

3. Insert the new filter into the filter case ( 4 ).
4. Push the filter, and then turn it clockwise until
it locks.
• If you have trouble inserting the water
filter because of high water pressure,
shut off the water supply valve.
• The locked symbol should be lined up
with the indicator line.
5. Touch the "Alarm/hold
3 sec for Filter Reset"
button (
(Filter Reset)
about 3 seconds to reset
the water filter. The color
of the indicator (
changes from red to off.
6. If you turned off the water supply, turn it back
on.
For a replacement water filter, you can visit
your local home Improvement center or
contact the Samsung Parts distributor.
To order more water filter cartridges,
contact your authorized Samsung dealer.
Be sure the replacement water filter has
the SAMSUNG logo on the box and on the
water filter.
20 English
RF30KMED_DA68-02894B-02_EN.indd 20
4
) for
)
Removing any residual matter inside
the water supply line after installing
the water filter.
1. Turn ON the main water supply and supply
water from water supply line.
2. Run water through the
dispenser until the water
runs clear (approx. 6 to 7
minutes). This will clean
the water supply system
and remove air from the
lines.
3. Additional flushing may be required in some
households.
4. Open the Refrigerator door and make sure
there are no water leaks coming from the
water filter.
Be sure to flush the dispenser thoroughly,
otherwise water may drip from the
dispenser.
This means that there is still air in the line.

Reverse Osmosis Water Supply

IMPORTANT:

The pressure of the water supply coming out of a
reverse osmosis system going to the water inlet
valve of the refrigerator needs to be between 35
and 120 psi (241 and 827 kPa).
If a reverse osmosis water filtration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs to
be a minimum of 40 to 60 psi (276 to 414 kPa.) If
the water pressure to the reverse osmosis system
is less than 40 to 60 psi (276 to 414 kPa):
• Check to see whether the sediment filter in the
reverse osmosis system is blocked. Replace
the filter if necessary.
• Allow the storage tank on the reverse osmosis
system to refill after heavy usage.
• If your refrigerator has a water filter, it may
further reduce the water pressure when used
in conjunction with a reverse osmosis system.
Remove the water filter.
If you have questions about your water pressure,
call a licensed, qualified plumber.
2017-05-23 5:15:22