Dicota Switch Manual De Instrucciones página 2

english
Introduction
This wireless optical mouse set consists of:
• Mouse
• Receiver
• 3 exchangeable covers
• 2 AAA rechargeable batteries
• Recharge cable (can be optionally used)
Unique Feature:
The mouse can be used with or without the
cable.
Technical specifications:
Optical resolution
Transmitter working
voltage
Transmitter working
current
Receiver working
voltage
Receiver working
current
Receiving distance
Transmitter working
frequency
Receiver working
frequency
Working temperature –15° C – > 50° C
Working humidity
Storage temperature
Storage humidity
System Requirements:
Hardware:
• IBM PC or compatible
• USB Port
800 dpi
1,8 V–5 V
less than 35 mA
4,5 V–5 V
less than 25 mA
up to 1 meter
27.042 MHz
26.590 MHz
10% – > 85% RH
–15° C – > 60° C
less than 90% RH
Operation system:
• Windows 98 SE/ME/2000/XP
Caution: The scrolling wheel and the third
button only work with the above mentioned
operation systems, otherwise the mouse
equal to the standard two button mouse.
Connecting the mouse receiver:
1. Turn off your computer.
2. Plug the USB receiver into an available
USB port on your computer.
Push
to open
Insert the batteries (Figure 1):
1. Put the ON/OFF switch on the bottom of
the mouse to the "OFF" position.
2. Press the battery cover button on the top
of the mouse then remove the battery
cover from the top of the mouse.
3. Making sure the batteries positive (+) and
negative (–) ends of each battery match
the polarity indicators inside the battery
housing.
Note: The battery cover is top cover of the
mouse.
Warning: Use only rechargeable batteries
when charging the mouse or it could cause
explosion.
4. Close the battery cover.
5. Put the ON/OFF switch on the bottom of
mouse to the "ON" position. The optical
Fig. 1