König Electronic SEC-ALARM210 Manual De Uso página 5

(B)
(B)
(A)
(A)
(C) (C)
(A) Red marking on this side
(B) Magnet
(C) Sensor
After mounting the sensor, test it by opening and closing the door or window. The control centre should
respond in the same way as described in step 4.
Synchronising the motion detection sensor(s) to the control centre:
Before starting the process, first insert a 9 V alkaline battery (not included) into the battery
compartment.
Test button
Indicator
underneath
the lens
Control centre will not respond to the motion detection sensor unless:
1) The control centre is armed in away mode (it will only respond to motion detection sensors in zones
1, 2 and 3)
2) Motion detection sensor is programmed into zone 4, which is a dedicated alert zone.
It is important to select which zone you program the motion detection sensor to. If you set up the
motion detection sensor for security purpose where it will cause an alarm with an intruder break-in,
you should program the motion detection sensor to either zone 1, 2 or 3. DO NOT program it to zone 4
as it is a dedicated alert zone. Sensors in this zone will not cause an alarm.
If you set up the motion detection sensor for alert purposes where it does not need to cause an alarm
when motion is detected, you should program the motion detection sensor to zone 4. DO NOT
program to Zone 1, 2, or 3, as motion detection sensors in these zones will not provide any alert
5