Overview
CEILING MOUNT BRACKET for camera to be installed on the
ceiling.
SBR-100DCM is a bracket to be used in installing SmartDome
Camera on a double-layered ceiling.
Notice
•
Make sure that the place for installation can stand the weight of about 4kg of the
SmartDome Camera before making installation.
•
Install the device in the spot where more than 180mm in space is provided above the
ceiling board.
•
It can be installed only when the ceiling board is more than 40mm thick.
•
Make sure to use a safety wire that can prevent falling.
•
When you install the camera on the bracket, be sure to use the fixing screw which is
provided with the bracket.
180mm or above
Ceiling
1
40mm or less
Installation
1
Drill holes using the template A.
1. First drill 4 holes in ø12.
2. Remove the central part of the template ( "C" ).
3.Drill a hole in ø185.
The shape of the hole is as follows:
Template
2
Install two anchor bolts on the concrete ceiling.
1. Install one in the center the hole of ø185.
•
Determine the length of the anchor bolt using the template B (accessory).
•
Apply a nut to the anchor bolt using template B (accessory) and determine
the location.
2. Tighten another anchor bolt (2) as shown on the following drawing.
(2)
(1)
"D"
Anchor bolt
"E"
Template B
Ceiling board
GB
2