Contents; Quick Start - NEC AccuSync LCD51VM Manual Del Usuario

Contents

Your new NEC AccuSync LCD monitor box* should contain the following:
• AccuSync LCD monitor with tilt base
• Audio Cable
• Power Cord
• Video Signal Cable
• User's Manual
• CD-ROM
User's Manual Audio Cable
Remember to save your original box and packing material to transport or ship the monitor.
*

Quick Start

To attach the Base to the LCD Stand:
1. Insert the front of the LCD stand into the holes in the front of the Base (Figure S.1).
2. Next, position the locking tabs on the back side of the LCD stand with the holes on the Base. Lower the Stand in place until
locking tabs are secure (Figure S.1).
Stand
2
Locking Tabs
Base
Figure S.1
To attach the AccuSync LCD monitor to your system, follow these instructions:
1. Turn off the power to your computer.
2. For the PC with Analog output: Connect the 15-pin mini D-SUB signal cable to the connector of the display card in your
system (Figure A.1). Tighten all screws.
For the Mac: Connect the MultiSync Macintosh cable adapter (not included) to the computer. Attach the 15-pin
mini D-SUB signal cable to the MultiSync Macintosh cable adapter (Figure A.2). Tighten all screws.
NOTE: Some Macintosh systems do not require a Macintosh cable adapter.
01_English
Power Cord Video Signal Cable
1
Front Base
Holes
2
CD-ROM
Base Stand
Macintosh Cable
Adapter (not included)
Figure A.1
English-2
20/05/2003, 11:44
AccuSync LCD monitor
(base stand not connected)
Figure A.2