LEMAN TAB 110 Manual De Instrucciones página 43

Use safety glasses. Use face or dust mask if cutting operations create dust.
10. Connect dust extraction equipment
If devices are provided for the connection of dust extraction and collecting equipment, ensure
these are connected and properly used.
11. Do not abuse the cord
Never yank the cord to disconnect it from the socket. Keep the cord away from heat oil and
sharp edges.
12. Secure work
Where possible use clamps or a vice to hold the work, it is safer than using your hand.
13. Do not overreach
Keep proper footing and balance at all times.
14. Maintain tools with care
Keep tools sharp and clean for better and safer performance.
Follow instructions for lubricating and changing accessories.
Inspect tool cords periodically and if damaged have them repaired by an
authorized service facility.
15. Disconnect tools
When not in use, before servicing and when changing accessories such as blades, bits and
cutters, disconnect tools from the power supply.
16. Remove adjusting keys and wrenches.
Form habit of checking to see that keys and adjusting wrenches are removed from the tool
before turning it on.
17. Avoid unintentional starting
Ensure switch is in "off" position when plugging in.
18. Use outdoor extension leads
When the tool is used outdoors, use only extension cords intended for outdoor use and so
marked.
19. Stay Alert
Watch what you are doing, using common sense and do not operate the tool when you are
tired.
20. Check damaged parts
Before further use of tool, it should be carefully checked to determine that it will operate
properly and perform its intended function.
Check for alignment of moving parts, binding of moving parts, breakage of parts, and any other
conditions that may affect its operation.
A guard or other part that is damaged should be properly repaired or replaced by an authorized
service center .
Have defective switches replaced by an authorized service center.
Do not use the tool if the switch does not turn it on and off.
21. Warning!
The use of any accessory or attachment other than that recommended in this instruction
manual may present a risk of personal injury.
22. Have your tool repaired by a qualified person
Repairs should only be carried out by a qualified person using original spare parts, otherwise
may result in considerable danger to the user.
２
EN