MRA Cupolino Instrucciones De Montaje página 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA screen
1 Edge protection strip, clamp sleeves
Fitting the screen to the motorcycle:
1. Position the motorcycle on a level surface.
2. Remove the fixing srew of the speedometer unit and pull off the unit from the
clamping.
3. Remove the six screws of the screen.
4. Remove the nuts from the mirror mount.
5. Loosen the turn signal plug connections and remove the mirrors.
6. Remove the original screen and insert the rubber nuts into the MRA screen.
7. Assembly in reserve order.
8. After the screen is in place, the edge-guard can be fitted on. The two ends should be
cut flush with a pair of scissors. The clamp sleeves are then slipped over those ends
and squeezed shut with a pair of pliers.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
SUZUKI GSX-R1000 2005-
Article No..
--- Allen key 4mm
--- Ring Spanner 10mm
Srew driver PH 2
Combination pliers
3
Required tools