Roadstar PCD-498MP Manual De Instrucciones página 4

1 English
LOCATIONS OF CONTROLS
1. LCD DISPLAY
2. PLAY/PAUSE
3. STOP
4. SKIP-/SEARCH
5. SKIP+/SEARCH
6. PROGRAM
7. MODE
8. OPEN SWITCH
9. CD DOOR
10. VOLUME
11. PHONE JACK
12. DC INPUT JACK
13. RECHARGE SWITCH
14. BATTERY COMPARTMENT
POWERSUPPLY
Use with regular batteries
1. Open the battery compartment door, located on the bottom of the unit, by sliding the
door and lift it up. (Do not remove the battery door).
2. Insert 2 x 1.5V /UM-3/AA size alkaline batteries, following the correct polarity, as in-
dicated in the battery compartment.
3. Close the battery compartment door. If the symbol "LOW BATTERY" appears in the
display, batteries are weak and ought to be replaced.
Use with AC/DC adaptor (included)
1. Insert the DC plug, at the end of the AC/DC adaptor cord, into the DC 5 V INPUT
socket (12) located on the back of the unit.
2. Connect the AC/DC adaptor into a 100-240V ~ 50-60 Hz AC power outlet.
Notes:
If the AC adaptor is connected when regular batteries are installed, the power supply

automatically switches to the AC power source.
Use only the supplied AC/DC adaptor. Using other types of adaptor may damage the

unit.
Make sure that the AC/DC adaptor matches with your household voltage before con-

necting it into the wall outlet.
When not using AC power, disconnect the AC/DC adaptor from the wall outlet.

Do not touch the AC/DC adaptor with wet hands.

Use rechargeable batteries
1. Disconnect the AC/DC adaptor from the wall outlet if it is being connected to the
unit.
2. Open the battery compartment door as mentioned previously.
3. Insert 2 recommended rechargeable batteries, following the correct polarity as indi-
cated in the battery compartment.
4. Close the battery compartment door.
5. Move the RECHARGE SWITCH (16) to ON to start recharging function. The red
CHARGE indicator (17) will light up.