Denon Professional CONVOY Guia Del Usuario página 7

Operation
Wireless Microphone Setup
To use a wireless mic, follow these setup
steps:
1. Connect the UHF antennas to Convoy.
2. Install 2 new AA alkaline batteries (not
included) in the wireless microphone.
3. Adjust the Line/Mic/Wireless Mic switch to
the Wireless Mic position for the channel
that you want to use with the wireless mic.
4. Pair the wireless mic to Convoy.
a. Turn on Convoy and the wireless mic.
b. Use the Up/Down buttons to select a
channel with the best reception, from
1–16.
c. Place the wireless microphone IR
sensor near the receiver's IR LED and
press the Pair button on the receiver.
Wait for about 3 seconds until the IR
LED stops flashing. When it finds an
interference-free channel, the RF LED
will illuminate on the receiver showing
the mic is matched to that channel.
5. As you speak, adjust the channel Volume
knob on Convoy for more or less output
signal.
6. Repeat steps 1-5 to pair to another wireless
mic.
Note: The left side UHF module is always set to Group 1 and the right side UHF module is
always set to Group 2.
Note: When using two wireless microphones (or other transmitters) with Convoy, the two IR
receivers must be set to separate UHF groups. Pairing two transmitters on the same group
may result in feedback.
To change the wireless channel, use the Up/Down buttons on the receiver. The wireless
microphone may show a different channel or group on its display, but the wireless connection
will remain active. However, if the wireless channel or group is changed from the transmitter,
you will need to resync with the receiver by following the steps above.
If the signal is interrupted or the receiver becomes disconnected from the wireless
microphone, the RF LED will no longer be lit. Follow the directions above to resync the
receiver and transmitter.
IR LED
RF LED
UP
PAIR
DOWN
IR sensor
7