LG WM20WV26W Manual Del Propietário página 57

global_main.book.book Page 15 Wednesday, July 29, 2020 2:12 PM
completely to the tap and then tighten the
hose by screwing it to the right.
Connecting One Touch Type Hose to Tap
Without Thread
1
Unscrew the adapter ring plate
the 4 fixing screws.
2
Remove the guide plate
to fit the adapter.
3
Push the adapter onto the end of the tap so
that the rubber seal is connected to be
and loose
d
if the tap is too large
e
INSTALLATION
watertight. Tighten the 4 fixing screws and the
adapter ring plate.
4
Pull the connector latch plate
the inlet hose onto the adapter, and release the
connector latch plate. Make sure the adapter
locks into place.
NOTE
• After connecting the water inlet hose to the
water tap, turn on the water tap to flush out
foreign substances (dirt, sand, sawdust, and etc.)
in the water lines. Let the water drain into a
bucket, and check the water temperature.
15 EN
down, push
f