Peaq PMS200BT-B/W Manual De Instrucciones página 42

ENGLISH
CD playback
Press MODE and select CD.
EJECT / LOAD A DISC
1. Open the CD tray by pressing OPEN/
CLOSE or
tray cover will open upwards. Remove
the transport safeguard when opening
the CD tray for the first time.
2. Put one CD into the CD tray with the la-
bel side facing up. Press on a point in the
middle of the CD until it clicks into place
on the axis.
3. Press OPEN/CLOSE to close the CD
tray. The CD will now be read.
4. The total number of tracks on the CD is
displayed on the screen and will play the
first track automatically.
NOTE: Before you open the CD tray again,
always press
spinning. To remove the CD, place one finger
in the middle of the CD (middle of the spin-
dle) and the other finger on the edge of the
CD. Carefully pull the CD out of the tray.
REPEAT FUNCTION
Press REPEAT to select the following repeat
modes:
– REPEAT
– REPEAT ALL
– REPEAT ALBUM
NOTE: Repeat album will be displayed only
for CD with MP3/WMA music files.
42
PMS200BT_A5_131031_1.indb 42
on the touch panel. The CD
first to stop the CD from
repeat current track
repeat all tracks
repeat album
FOLDER SELECTION
For CD with MP3/WMA playback.
Press on the remote control to change
or
the folder.
ID3 OPERATION
For CD with MP3/WMA playback.
1. During MP3/WMA
MEMORY to turn on ID3 operation.
2. TITLE NAME / ARTIST NAME / ALBUM
NAME will be displayed on the screen.
3. Press MEMORY again to turn off ID3
operation.
PLAYBACK LIST
The playback list can only be programmed
in stop mode.
1. While in stop mode, press MEMORY,
track number 00 starts flashing.
2. Press or on the remote control to
select the track and confirm by pressing
MEMORY.
3. Up to 32 tracks can be programmed.
4. Press to play the first track of the
program.
NOTE: For CD with MP3/WMA music files
you can can follow the steps in USB/CARD
playback.
CANCEL PLAYBACK LIST
In stop mode, press to cancel the program
or open the CD tray by pressing OPEN/
CLOSE or on the touch panel.
playback, press
31/10/13 2:54 PM