Important; Agitator Assembly - Sears Kenmore 116.26212 Manual Del Propietário

TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacuum
cleaner, the agitator must be cleaned every
time the belt is chanqed.
The agitator must also be cleaned according
to the following schedule:
Vacuum Cleaner Use Clean Aaitator
HEAVY -
(used daily)
MODERATE -
(used 2-3 times/week)
LIGHT -
(used 1 time/week)
every week
every month
every 2 months
IMPORTANT
Disconnect vacuum cleaner from
electrical outlet. Check and remove hair,
string and lint build-up frequently in the
Power-Mate ® agitator and end cap areas.
Remove any dirt or debris in the belt path
area or in the brush roller area.
Carefully remove any string or debris
located on the agitator, or end caps.
AGITATOR ASSEMBLY
Belt Pulley_
Brush Unit
TO REPLACE BELT
1. Install new
belt over motor
drive, then
over belt
pulley.
NOTE: See
PARTS AND
FEATURES for
Belt number.
3. Reinstall
agitator
cover by
lining up the
front tabs
and slots
and rotating
downward
until the
latches
snap into place.
2. Place agitator
assembly back into
Power-Mate ® .
Tabs
Agitator Cover
,,Lineup
front of
cover and
base. Rest
cover on
front edge of
base as
shown.
Cover Base
5. Rotate cover
back. Press cover
firmly until side and
tabs snap into
place.
6. Turn Power-Mate®upside down and
replace two (2) cover screws.
16