Belt Changing And Agitator Cleaning - Sears Kenmore 116.26212 Manual Del Propietário

1. Remove Power-Mate ® cover as shown in
BELT CHANGING AND AGITATOR
CLEANING section.
Push In
And Turn
2. Push in and turn
bulb counterclock-
wise, then pull out
to remove.
_Pushlnl-- I
And Turn I I
3. Push in and turn
bulb clockwise, to
replace. Bulb must
not be higher than
15 Watts(130 Volts).
4. Reinstall Power-Mate ® cover as shown in
BELT CHANGING AND AGITATOR
CLEANING section.
NOTE: See PARTS AND FEATURES for
Bulb number.
IbWARNING
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before per-
forming maintenance to the vacuum
cleaner. Failure to do so could result in
electrical shock or personal injury from
vacuum cleaner suddenly starting, i
i
TO CHECK BRUSHES
When brushes
._r--------____[__[l__.are worn to the
level of the base
support bars,
Base Support Bars assembly.
TO REPLACE AGITATOR
ASSEMBLY
1. Remove Power-Mate ® cover, agitator
cover, belt and agitator assembly. See "To
Remove Belt" in BELT CHANGING AND
AGITATOR CLEANING.
2. Replace agitator assembly.
3. Reinstall belt, agitator cover and Power-
Mate ® cover. See "To replace belt" in BELT
CHANGING AND AGITATOR CLEANING.
17