IMPORTANT SAFETY INSTRUCTIONS FOR USING
STAPLER & NAILERS READ ALL INSTRUCTIONS
DANGER
and others in work area .
2. NEVER USE OXYGEN OR OTHER BOTTLED GASES.
EXPLOSION MAY OCCUR.
Never use oxygen, combustible gases or any other bottled gases as a power
source for the Tool . Use of the above gases is dangerous, as the tool will
explode . Use only clean, dry, regulated compressed air .
WARNING
3. NEVER POINT TOOL AT YOURSELF OR OTHERS IN WORK AREA.
Always assume the Tool contains fasteners . Never point the Tool at yourself, toward
yourself or others whether it contains fasteners or not .
If fasteners are mistakenly driven, it can lead to severe injuries . Never engage in
horseplay with the Tool . Respect the tool as a working implement .
4. DO NOT EXCEED 120 psi.
(6.2 bar 6.3 kgf/cm
Do not exceed maximum recommended air pressure
120 psi (6 .2 bar 6 .3 kgf/cm2) . Never connect the
Tool to pressure which potentially exceeds 200 psi
(13 .7 bar 14 kgf/cm2) as the tool can burst .
5. ALWAYS WEAR EAR AND HEAD PROTECTION.
Always wear ear protection to protect your ears from loud noise . Always wear head protection
conforming to ANSI Z89 .1-1986 to protect your head from flying objects .
6. STORE TOOL PROPERLY.
When not in use, the Tool should be stored in a dry place . Keep out of reach of children . Lock the
storage area .
7. KEEP WORK AREA CLEAN.
Cluttered areas invite injuries . Clear all work areas of unnecessary tools, debris, furniture, etc .
1. OPERATORS AND OTHERS IN WORK AREA MUST WEAR SAFETY
GLASSES WITH SIDE SHIELDS.
When operating the Stapler & Nailer, always wear eye safety glasses with side shields,
and make sure others in the work area wear safety glasses, too .
Safety glasses must conform to the requirements of American National Standards
Institute, ANSI Z87 .1 and provide protection against flying particles both from the front
and side .
The employer must enforce the use of safety glasses by the Stapler & Nailer operator
)
2
SAFETY
4
120 psi
200 psi