Ergo Fix 77200 Manual De Instrucciones página 23

• Break wood in the direction of the grain. Do not place wood across the log
splitter and leave it in that position for splitting; it may be dangerous and may
seriously damage the machine.
• Never attempt to cut two logs at once; one may fly up and hit you.
• If the log moves away from the blade, retract the ram or the blade and turn the
log through 90°.
• Do not attempt to load the log in the log splitter while the ram is in motion; you
could get trapped and injured.
• Keep your hands well away from any splits and cracks which open in the log;
these may close suddenly and crush or amputate your fingers.
• Never force the log splitter for more than 5 seconds keeping the cylinder
under pressure in the attempt to split excessively hard wood. After this time
interval, the oil under pressure is overheated and the machine could be
damaged. It is thus better to stop and rotate the log by 90° to see whether it can
be split in a different position. In any case, if you are not able to split the log, this
means that its hardness exceeds the capacity of the machine and thus that the
log should be discarded so as not ot damage the log splitter.
• Do not force the blade by pushing the log on the upper part; as this can cause
the blade to break or damage the body of the machine. Always set the log on
the guides.
• Never leave the machine unattended while it is running. If you leave the
machine, even for a short time, remove the power supply or any possible cause
of accidental start-up.
• The log splitter must never be used by an operator who is under the influence
of alcohol, drugs, medicines, or who is tired. A clear mind is essential for safety.
• Never request the assistance of another person to help you remove a jammed
log.
• Check that the electric circuit is adequately protected and that it corresponds
with the power, voltage and frequency of the motor. Check that there is a
ground connection and a regulation differential switch upstream.
• Use cables with a section of 2,5 mm². Avoid use of free and inadequately
insulated connections. Connections must be made with protected materials
suitable for outdoor use. Do not use cables over 10 metres long, as excessively
long cables or those with inadequate section can cause voltage drops that
prevent motor from developing its full power.
• Never open the pushbutton box on the motor. Should this be necessary,
contact a qualified electrician.
• Make sure that the machine and the cable never come in contact with water.
• Treat the power cable with care. Do not attempt to move the machine by pulling
the cable. Do not yank the cable to unplug it; keep the cable away from
excessive heat, oil and sharp objects.
• Never leave the machine unattended with the power supply "on". Also
disconnect the power cable when not in use, when carrying out maintenance
work, when changing attachment or moving the machine.
21