Sears Kenmore 473.85920 Manual Del Propietário página 24

CLEAN THE BRUSH
Unplug carpet cleaner from electrical outlet.
Remove solution and recovery tanks to prevent
possible leaks.
Tilt cleaner back onto the floor, resting it on its side.
_Squeeze filter frame (A) and pull it out until it
stops. Do not completely remove frame.
Wipe debris off filter.
Slide filter back in place.
Empty solution tank and rinse thoroughly. Let air dry.
Place empty solution tank on carpet cleaner. Turn carpet cleaner ON. Squeeze trigger and push
carpet cleaner forward and back several times. This will clear any solution remaining inside the
cleaner.
Empty recovery tank, rinse thoroughly and let air dry. Remove water from the hose (see "After
using tool", page 16.)
Allow brushes and underside of carpet cleaner to air dry thoroughly before storing carpet
cleaner on a carpeted or wood surface.
The motor is equipped with bearings which contain sufficient lubrication for the life of the motor.
The addition of lubricant could cause damage. Do not add lubricant to motor bearings.
24