Assembly Instructions; Electrical Connection; Power Requirements; Connection - BOMANN EK 6024 CB Manual De Instrucciones

I Timer active ( )
J Standby ( )

Assembly Instructions

This appliance is intended for permanent attachment to a
wall. It should be placed at least 30 cm above the ground.
Please refer to the figures on page 4.
Do not switch on the appliance until it has been prop­
erly installed!
WARNING:
Make sure beforehand whether there are cables inside
the wall which could be damaged!
CAUTION:
• The wall should be a load bearing and heat resistant
wall.
• The subsequent work requires manual skills. If neces-
sary, get help from a specialist
NOTE:
• There must be a power outlet nearby, but not above
the appliance. The hot air flow is emitted by the fan at
the top of the appliance.
• Route the power cord right behind the appliance.
• In order to have an optimal view at the fireplace, we
recommend installing it onto a height of 60 cm (see
Fig. A).
• Use a size 8 drill bit to drill holes into the wall.
• You will also need a medium sized Phillips screwdriver.
1. Measure the height at which you want to mount the
appliance. The recommended dimensions can be found
in Fig. B.
2. Use 5 screws and dowels to attach the mounting strip
horizontally to the wall.
3. Attach the mounting bracket with the threaded screws to
the appliance (see Fig.C).
4. Hang the appliance into the mounting strip on the wall.
5. Mark the positions of the 2 boreholes for the mounting
bracket.
6. Remove the appliance from the wall once again.
7. Drill the 2 holes for the mounting bracket. Insert the
dowels.
8. Hang the appliance into the mounting strip on the wall.
9. Use 2 screws to attach the mounting bracket to the wall.

Electrical Connection

Power Requirements

The appliance can consume a total of 2000 W. With this
connected load a separate supply line protected by a 16 A
household circuit breaker is recommended.
20
CAUTION: Overload!
• If you use extension leads, these should have a cable
cross-section of at least 1.5 mm².
• Do not use any multiple sockets, as this appliance is
too powerful.
• Do not connect any other powerful appliances to the
same electric circuit.

Connection

• Make sure that the iron voltage and the line voltage
match. The nameplate is located at the bottom of the
appliance.
• The mains plug should only be inserted into a correctly
installed socket with earthing contact.

Remote Control

Inserting the Battery
A lithium button cell is supplied with the remote control.
• To operate the remote control, remove the plastic strap
that protrudes from the battery compartment.
Replacing the Battery
• Press the tab on the remote control battery compartment
toward the centre. Now pull out the battery compart-
ment.
• Remove the used battery.
• Insert a new CR2025 3 V button cell, observing the
correct polarity.
• Slide the battery compartment back into the remote con-
trol until the tab snaps into place.

Remote Control Range

• The remote control has a range of approx. 3 meters.
If the range decreases you should change the
• Make sure there are no obstacles between the remote
control and the sensor of the appliance. It is located in
the upper right area of the glass front.
battery.