Dip-Switch Functions - KEY CT-2-24S Manual De Instrucciones

DIP-SWITCH FUNCTIONS

Dip N° FUNCTION
Dip 1 Step/step P/P
Dip 2 Electronic clutch
Dip 3 Automatic closing
Dip 4 1 or 2 Motors
Dip 5 Slow motion
percentage
Dip 6 Battering ram
Dip 7 Door delay
Dip 8 Phototest
N.b.:each function variation is confirmed upon completion of closure
The tests of maximum force were carried out in the following conditions:
A. Weight for each door 200Kg. Length of each door 2mt.
B. Setting of Dip switch: Dip2=OFF Dip5=ON Dip4=OFF
The setting of the other dip-switches does not affect the result of the test
ON
First Impulse Opens and accepts only
re-opening during closing
Maximum Force – minimum sensitivity
to obstacle
Automatic closure activated, enables
Automatic Operation
Operation with 1 Motor
30% deceleration of travel
Before opening performs a brief
closing of door M1
In closing door M1 is activated after 7
sec.
Enabled, at each opening a check is
made of connected device
19
OFF
One Impulse Opens
One Impulse Stop
One impulse Closes
(whether using input P/P Term.
N.15 or from the Remote Control)
Minimum Force – Maximum
sensitivity to obstacle
Automatic Closure not enabled,
Semi-automatic Operation enabled
Operation with 2 motors
10% deceleration of travel
Disabled
In closing door M1 is activated after
3 sec.
Disabled
GB