Declaration Of Ce Conformity; Introduction; Technical Characteristics; Wood - Fogo Montanha E600 Manual De Istrucciones

DECLARATION OF CE CONFORMITY

We, the manufacturers of the appliance, hereby declare under our sole responsibility that the products described below
conform to essential safety requirements. This declaration will be rendered invalid if any changes are made to the
appliance without our written consent
Manufacturer
Classification
Applied Standards and Directives
Test Institute

1. INTRODUCTION

Thank you for buying a FOGO MONTANHA stove. To get the best ecological performance and highest output from this
appliance please follow these installation and operating instructions. The guarantee will cease to apply if the stove is
damaged as a result of a failure to follow the installation and operating instructions. The appliance must not be
modified without the manufacturer's written permission. Only original spare parts made by the manufacturer should be
used to repair this appliance. Prevailing laws and local architectural and fire prevention regulations must be followed.

2. TECHNICAL CHARACTERISTICS:

Model
Nominal efficiency
Nominal wood consumption
Maximum heated volume
Minimum to maximum heat output
CO emissions (at 13% oxygen)
CO2 emissions
Chimney diameter
Nominal heat output
Safety distance from front of stove
Weight
Fuel
Maximum humidity of wood
Maximum length of log
Dimensions:
Height
Width
Depth

3. WOOD

The stove burns only wood. The best results are obtained using dry wood. Logs cut to size, stored and ventilated under-
cover for at least one year and preferably two, are best as they:
Produce considerably more heat than wet or green wood.
Produce much less smoke and deposit less tar on the stove, chimney and glass panel than wet or green
wood. Only dry wood prevents emissions of hazardous substances when burning.
A stove full of wood will generate more heat over a longer period of time. Logs should not be too large and, generally
speaking, the harder the wood the better. Never use waste, chippings, wood shavings and sawdust, tree bark or waste
from chipboard, laminated wood or surface-treated wood. Do not cut the firewood too small. Very thin pieces of wood
burn very quickly and are only suitable for lighting the stove. Allow large pieces with the normal dimension of about 25cm
to burn naturally. Large logs must be chopped small.
Note: The stove is not a waste incinerator. The environment legislation expressly forbids the burning of waste in house-
hold fires. Not only is it environmentally unfriendly to use a solid fuel stove incorrectly to burn household waste, chemi-
cally treated wood waste or waste paper, or to use it as a private waste incineration plant, but it is also in breach of the
emission laws and liable to punishment. The appliance is not suitable for burning liquid fuels. Besides creating high and
unchecked air pollution, harmful combustion products and combustion residues it also has a negative effect on the
working and operating life of the stove and flue. This results in all kinds of defects and rapid wear, which may require
expensive repair and even replacement of the stove. The burning of unsuitable fuels can lead to a house fire of a type not
covered by your fire insurance.
Solzaima, S.A.
Rua dos Outarelos, 111
3750-362 Belazaima do Chão, Portugal
Tel: +351 234650655 Fax: +351 234650651
Aparelho de combustível sólido; Insert
EN13229 : 2001+ A1:2003 + A2:2003:2005
Laboratório Recupera
Universidade do Algarve
Campus da Penha
8005-139 Faro
E600
75
%
2,6
Kg/hour
229
m3
5,5-10,1 6,4-11,8
kW
0,2
Vol.%
10,1
Vol.%
150
mm
7,8
kW
100
cm
83
kg
wood
20
%
40
cm
530
mm
600
mm
430
mm
10
E600H E700
Vitro 700
78 77
2,4 3,0
268 294
7,0-13,0 7,8-14,6
0,1 0,2
9,7 10,8
180 180
9,1 10,0
100 100
105 118
wood wood
20 20
40 50
720 600
600 700
450 450
E800 E800F
Vitro 800F Vitro 900F
80 77
3,5 3,4
329 329
7,8-14,6
0,2 0,2
11,4 10,8
200 200
11,2 11,2
100 100
136 108
wood wood
20 20
50 60
670 600
800 800
470 470
E900F
75
3,1
323
7,7-14,3
0,2
9,9
200
11,0
100
112
wood
20
70
600
900
470