Installation; Points To Be Paid Attention To When The Relocation Of The Refrigerator; Before You Start The Refrigerator; Electrical Connection - Grundig GFNI12430N Manual Del Usuario

3. Installation

B
In case the information which are
given in the user manual are not taken
into account, manufacturer will not
assume any liability for this.
Points to be paid attention
to when the relocation of the
refrigerator
1. Your refrigerator should be
unplugged. Before transportation of
your refrigerator it should be emptied
and cleaned.
2. Before it is re-packaged, shelves,
accessories, crisper, etc. inside your
refrigerator should be fixed with
adhesive tape and secured against
impacts. Package should be bound
with a thick tape or sound ropes and
the transportation rules on the
package should be strictly observed.
3. Original packaging and foam materials
should be kept for future
transportations or moving.

Before you start the refrigerator

Check the following before you start
to use your refrigerator:
1. Is the interior of the refrigerator dry
and can the air circulate freely in the
rear of it?
2. Clean the interior of the refrigerator
as recommended in the
"Maintenance and cleaning" section.
3. Connect the plug of the appliance to
the wall socket.
4. When the compressor starts to
operate, a sound will be heard. The
liquid and gases sealed within the
refrigeration system may also give
rise to noise, even if the compressor
is not running and this is quite
normal.
5. Front edges of the refrigerator may
feel warm. This is normal. These
areas are designed to be warm to
avoid condensation.

Electrical connection

Connect your product to a grounded
socket which is being protected by a
fuse with the appropriate capacity.
Important:
The connection must be in compliance
with national regulations.
• The power plug must be easily
accessible after installation.
• Electrical safety of your refrigerator
shall be guaranteed only if the earth
system in your house complies with
standards.
• The voltage stated on the label
located at left inner side of your
product should be equal to your
network voltage.
• Extension cables and multi
plugs must not be used for
connection.
B
A damaged power cable must be
replaced by a qualified electrician.
B
Product must not be operated before
it is repaired! There is the risk of
electric shock!
EN
FR
DE
ES
IT
7