Mounting Bracket - DeWalt DXCM024-0345 Manual De Instrucciones

AIR LINE INLET
The air line inlet (H) is 1/4" NPT
and is located on the on the
side of the hose reel .

MOUNTING BRACKET

The poly mounting bracket (F)
has a hose reel mounting pin (J)
that is removable so it can be
easily mounted on a wall.
LEAD-IN AIR HOSE
The lead-in hose (I) is
3/8" x 4' long and has a
swivel connection on one
end to prevent the hose
from twisting or kinking. This comes attached to the hose reel.
AIR LINE OUTLET
The air line outlet (A) is 1/4"
NPT and is located on the end
of the air hose (G) for
convienient connection to air
accessories or tools.
AIR HOSE
The air hose (G) is 3/8" x 50'
and is attached to the hose
reel.
BALL STOP
The ball stop (C) is adjustable
and allows the desired length
of hose to be permanently stored outside the hose real.
HOSE BEND RESTRICTOR
The hose restrictor (B) reduces bending stress near the fitting,
preventing damage and extending the life of the air hose (G).
INSTALLATION
1. Choose a mounting location
that is free of electrical wiring
or other obstructions and is
sturdy enough to support the
weight of the hose reel and
hose as well as the force
used to extend and retract it.
The hose reel is to be mount-
ed on a wall. (see Figure 2).
2. Use the included mounting template to mark and drill the hole
locations.
3 Mount the hose reel bracket in the desired location. Purchase the
appropriate fasteners at your local hardware store.
4. Slide the hose reel mounting pin (J) into the bracket (F) and
secure with cotter pin (J1) through the hole in (J).
5. If an adjustment needs to
made to increase or decrease
the length of hose that is out-
side of the hose reel, pull out
the hose slowly until it latches
at the desired length. Pull up
on the ratchet lock (K) and
slide the ball stop (C) to a
position close to the hose
guide (D). Lock in place by closing the ratchet lock (K).
WARNING:
1) Make sure the hose reel is secure before each use.
6
Figure 2