Service Information - DeWalt DXCM024-0345 Manual De Instrucciones

5. Remove the ball stop by pulling up on the ratchet lock. Set aside.
6. Carefully pull all of the air hose from the hose reel and then lock
in this position. Do not allow the hose to retract back.
WARNING: The reel is under tension so do not turn the hose
reel drum or pull on the hose while it is locked.
7. Using the crank (N) on the right side of the hose reel, rotate coun-
terclockwise until the spring is feeling loose and the hose does
not retract back.
8. Spin the wheel manually to the position where the the hose can
easily be removed.
9. Loosen the hose clamp (Q) and remove the old hose.
10. Push the new hose onto the elbow (R) and tighten the hose
clamp.
11. Using the crank (N) on the right side of the hose reel, rotate
clockwise until the spring has tension. Pull the hose to unlock
and slowly rewind the air hose. Do not let go of the hose. Push
the crank handle back to lock in place.
12. Assemble the front cover back onto the hose reel & tighten the 2
screws.
13. Re-attach the ball stop to the desired location on the hose.
14. Place the side covers back onto the hose reel.
15. Reconnect the air supply. Check all connections to make sure
there are no leaks.

SERVICE INFORMATION

Please have the following information available for all service calls:
Model Number _____________________________________________
Date and Place of Purchase _________________________________
8