Product And User Description - König SEC-SA100 Manual De Uso

Product and user description:

3
1
3
2
1. Test button / battery indicator
Testing the smoke alarm
Like any other electronic device, smoke alarms are not foolproof. Smoke alarms contain electronic
components that can fail or wear out at any time.
We recommended that you test the smoke alarm every week to make sure it is working properly.
Push and hold the test button until the alarm sounds for a few seconds. If it does not sound, check if the
battery indicator flashes once every 45 seconds. If this is not the case, replace the battery immediately.
Battery indicator.
The battery indicator flashes every 45 seconds to show the smoke alarm is working properly. When the
battery indicator flashes and gives a short beep sound, it is indicating that the battery has low capacity and
should be replaced immediately.
2. Mounting plate
3. Mounting holes
Use the supplied screws and plugs to mount the
mounting plate to the ceiling.
4. Remove the mounting plate
Turn the mounting plate of the smoke alarm counter-
clockwise to get access to the battery compartment
of the smoke alarm.
5. Battery compartment
6. Safety catch
The safety catch prevents the smoke alarm being
returned to the mounting plate without inserting the
battery first.
7. Battery connector
Take off the plastic seal of the battery and connect
the battery with the battery connector. After placing
the battery test the alarm with the test button to ensure it is working properly (see testing the smoke alarm).
When the mounting plate is mounted and the smoke alarm tested after inserting the battery, place the
smoke alarm on the mounting plate by turning it clockwise.
3