Pf-1 Flashing Light - Accessmatic Dogo 1224 Manual De Usuario

d
ogo
1224
INSTALLATION:
Wire Connec�on of PH-2 Photocells See figure 4(2)
TX: Connect terminals 1 and 2 on the transmi�er with the terminals Ph+ and GND on the PC600 PCB.
RX: Connect DC and GND terminals to the to the PH+ can GND terminals of the control panel. Connect N.C. and COM termi-
nals to the PH1 and GND terminals of the control panel.

3.3.3 PF-1 Flashing Light

1). Decide the installa�on posi�on of the flashing light. The flashing light has to be installed near the gate and easy to be
seen by users and passersby. The flashing light can be installed horizontally or ver�cally. See Figure 3.3.3 (1).
2). Unscrew the four screws on the light base and separate the base with the bo�om as shown in Figure 3.3.3 (2).
3.) Connect the wires and penetrate the wires into the hole of the base. See Figure 3.3.3 (3).
4.) Drill the holes in the wall and fix the bo�om to the wall by three screws. See Figure 3.3.3 (4).
www.accessmatic.com
Opening your life
12