Name And Operation - Toshiba RBC-AS21E Manual Del Propietário

NAME AND OPERATION

• For Cooling Only type,
• Max. 8 indoor units can be operated by a remote controller.
• Once setting the operation items, you can operate the previous condition by pushing
button only.
<The following display is for explanation, so it differs from the real display.>
TEST
SETTING
1
2
3
1
Fan Speed button
2
Operation mode button
3
Swing/Air direction button
The flap angle is changed.
4
Temperature Setup button
Every pushing
rises by 1°C.
Every pushing
decrease by 1°C.
5
[Start/Stop] button
6
Check button (Used in servicing)
• Do not use this button usually.
7
Remote control temperature sensor
Usually controlled by the indoor unit
sensor, it can be changed to the
remote controller. For details, contact
the shop which you purchased the air
conditioner. (When using a group
control method, do not use the remote
controller sensor.)
• When turning on the power switch of the simple operation type remote controller at the first time,
flashes. While
Operate the remote controller after
, and are not displayed on LCD.
˚C
˚F
4
5
6
7
button, temperature
button, temperature
is displayed, the automatic model check is operating.
has disappeared.
8 9
10
TEST
11 SETTING
15 16
8
Selected mode displays (Heat pump type)
Any one of , , ,
While is displayed, the indoor fan stops or
the mode is Low speed mode.
9
Selected mode displays
(Cooling only type)
Any one of , or
10
TEST is displayed during Test Run.
11
(CHECK) is displayed when the protec-
tive device worked or trouble occurred.
12
is displayed during the operation.
If the remote controller setting is prohibited by
the central remote controller,
[Start/Stop], [Operation Select] or [Temp.
Setup] button is pushed and change is not
accepted.
13
The setup temperature is displayed.
14
Warning code is displayed when a trouble
occurred.
15
Selected fan speed,
displays.
16
is displayed when the remote controller
sensor is used.
2
12
˚C
13
˚F
14
or displayed.
is displayed.
flashes when
, , or