HQ EL-PILRLA90 Manual De Uso página 4

6. Place the solar board in a sunny location.
7. Adjust the motion detector direction.
It can be set at the range of 8second (counterclockwise rotation to the end) to 3mmute (clockwise
rotation to the end) The timer will recount when the sensor detects a movement signal before the end
of the last time, so we advise that you set the time to minimum when you carry out the detection
range test or the walking test.
Note: The sensor needs to wait 1 second to re-set after the light going off. Only at the end of the time
will the light turn on again when the signal is detected.
This range refers to the radii of the circular region that appears on the ground when the light is
installed in the 2 5 m height. A minimum detection range (nearly 4 m in radii) rotating a
counterclockwise rotation to the end. A maximum detection range (nearly 15 m in radii). rotating a
clockwise rotation to the end.
ATTENTION: When using this product, please adjust the sensitivity to the required position,
please do not adjust the sensitivity to maximum, to avoid the product malfunctioning due to
sensing the wrong motion. If the sensitivity is too high it will easily detect the wrong motion,
such as the wind blowing leaves & curtains, small animals, and the wrong motion by
interference of power grid & electrical equipment. All of these will prevent the product from
working normally!
When the product does not work normally, please try to lower the sensitivity appropriately,
and then test it.
8. Adjust the direction of the light head. 9. Insert the wire plug from the solar board into the
bottom of the light.
Make sure the wire plug is completely connected.
4