Homeguard BS8000 Manual De Usuario página 10

10. DE-ACTIVATING THE BUILT-IN MOTION SENSOR:
If you prefer to operate the HomeGuard only by means of the external alarm contact rather
than the built-in motion sensor, you can de-activate the PIR:
1. Enter your PIN (Personal Identification Num ber). Factory default is [0000]: You will hear
three high tones and one low tone as confirmation. The green indicator starts flashing.
2. Press 6 on the keyboard of the HomeGuard: One low tone is given for confirmation.
3. Press [ * ] for activating the PIR or # for de-activating the PIR: One tone is given for
confirmation and the INDICATOR stops flashing.
11. OPERATING INSTRUCTIONS:
When alarm occurs:
-4 minutes siren
-Dialler will dial first number and start transmitting the pre-recorded message as soon as
the last digit has been dialled. The message lasts 9 seconds and will be repeated twice.
The pre-recorded message is followed by a beep. After this beep the system will wait for
call confirmation which can be given by pressing "0" on a DTMF (touch tone) telephone. In
case the confirmation is not received, the system will start dialling the second number and
if needed the third number (all three number positions should be entered).
Arm-Disarm
The HomeGuard may be armed and disarmed by the remote control (option) or keyboard.
To activate the security system from the keyboard (always delayed):
Enter your PIN (Personal Identification Number).
Factory default is [0000]: You will hear three high tones and one low tone as confirmation.
The green indicator starts flashing.
Press # in the keyboard: You will hear one low tone as confirmation and the RED indicator
lights up, the GREEN indicator will flash during the delay (30 seconds).
After 30 seconds the HomeGuard is armed and will generate one low tone for confirmation.
To disarm the HomeGuard via the keyboard:
1. Enter your PIN code: 4 short tones will be generated as confirmation.
2. Press [ * ] : One short tone will be generated and the RED indicator will go out.
To arm and disarm the HomeGuard with the remote control (option):
1. Press ARM to activate the alarm. 2.Press DISARM to de-activate the HomeGuard.
If you use the remote, the arming and disarming may be instant of delayed, depending on
the settings of the HomeGuard.
To generate a panic call: press both PANIC buttons at the same time (option).
To reset the alarm: If an alarm has occurred it can be reset by:
HomeGuard revision 01-05-2005
10