Jonsered L4721 Manual Del Usuario página 25

• Remove the blade bolt by turning the bolt counter-
clockwise. Remove blade and attaching hardware:
bolt, lock washer and hardened washer.
• Remove the screw and the pulley.
• Pull out the belt and thread it over the adapter.
MAINTENANCE
Replace the drive belt
IMPORTANT! Always use genuine parts.
• Thread the new belt over the adapter and place the
belt on engine pulley.
• Route the belt over the stripper ring into the hole of
the chassis.
• Reinstall the transmission pulley and place the belt on
the pulley.
• Reinstall drive cover.
• Reinstall the blade. See instructions in the section
"Replacing the blades".
• Tighten spark plug.
English – 25