HE HWF5000AW Manual Del Usuario página 28

Repairs to the washing machine must only be carried out by qualified personnel. Repairs
carried out by inexperienced persons may cause injury or serious malfunctioning.
Contact your local service center.
Warning code
ErLC
ErUL
bloc punp
no taps
Err6
Err7 motor no rotation error
Err8
Er10 water level sensor error
EUAr between user interface
board and power board
Door
Abnormal item
door lock abnormal
door unlock abnormal
drainage abnormal
water inlet error
motor error
water over flow error
communication error
The door is not closed
Solution
Push the door to check whether it is properly close;
cut off the power and then turn on again.
If error still exist, please contact service personnel.
Cut off the power and then turn on again. If error still
exist, please contact service personnel.
Cut off the power.
Check if the drain hose is bent or clogged.
Check if the height of the drain hose end is more
than 96" above the floor.
Check if the drain filter is clogged.
If error still exist, please contact service personnel.
Check the two water inlet hose nuts to see if they are
properly fixed.
Check if the inlet hoses are bent or clogged.
Check if the water tap is not turned on.
Check if the water supply is failed.
If the problem is solved, press the Start/Pause button
to continue the cycle; If error still exist, please contact
service personnel.
Please contact service personnel.
Please contact service personnel.
The washer will auto drain out of water, and then
auto clean up; If error still occur, please contact
service personnel.
Please contact service personnel.
Please contact service personnel.
Close the door well, then press the Start button
again.
English
26