Cleaning And Maintenance - Melchioni MINERVA 2 Manual De Usuario

• Tighten the regulator to the cylinder to prevent gas leakage.
• Check that the gas hose is not twisting. In case, rotate the pipe in order that every twist
or curve is eliminated and the tube has a linear shape.
• Turn the cylinder's valve knob until fully open in order to allow the gas LPG to feed the
stove.
• Keeping the stove taps closed for fice minutes and check does not spread out smell of
gas before proceeding with the use of the stove.
• To verify that the installation has been done successfully, pour soapy on the joints of
every connection. Any leaking will be well visible using this solution.
• Attention: Never use a flame to check the Gas leaking.
Product's use
• Lightly press and turn counterclockwise the burner valve's knob according the burner
you want use.
• Put a lighter close to the defined burner
• Wait until the burner is fully switch ON and adjust the flame by turning the knob clockwi-
se or counterclockwise according your needs .
• To make the temporary shutdown of the burner , turn the knob clockwise to the OFF
position.
• After cooking , or before storing the product, turn OFF the burner by turning clockwise
the cylinder valve's knob tilli s close and wait for the complete extinction of the flame
. then rotate also the burner valve's knob to OFF position. This eliminates residual gas
inside the tube and in the stove as well .
• Wait until the stove is cold before moving or storing, at least 30 minutes.

CLEANING AND MAINTENANCE

• Regularly clean your Stove between uses and especially after extended periods of stora-
ge.
• Before proceeding with cleaning and maintenance of the product , make sure that the
stove is properly cooled ; wait at least 30 minutes after the last use .
• Ensure that the cylinder valve and the burner's valve are in the closed position . Remove
the grid to perform the cleaning more conveniently .
• Use a damp sponge to remove heavier dirt , a damp cloth and then a dry cloth are enou-
gh to clean and dry all surfaces .
• Never use abrasive substances , solvents or flammable .
• The only maintenance required for this equipment are the gas pipe and the cylinder.
Always make sure that these components are comply with current regulations and main-
tained in good working order . Always use the new gaskets supplied with the cylinder to
ensure the seal between regulator and cylinder