Craftsman ZT 700 Manual Del Operador página 28

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

GROUND
SPEED CONTROL
LEVER
ADJUSTMENT
The control levers have three adjustments:
To Adjust Control Lever Height: Pull the levers in
across the operator's lap to their DRIVE positions.
Loosen the mount bolts (D, Figure 34) and raise or lower
the levers to the desired position. Tighten the mounting
bolts.(D).
To Adjust Control Lever End Gap: The control lever
end gap should be adjusted so that the levers do not
contact each other when placed in DRIVE positions.
Loosen the jam nut (A, Figure 34) and adjust the length
of the carriage bolt (B) so that the levers do not contact
each other. Repeat on the opposite side. Tighten the
jam nut (A) to lock the carriage bolt in position.
To Adjust Operator
Clearance:
The space between the
operator and the control levers can be increase by
removing the lower mounting bolt (D, Figure 34), pivoting
the lever forward, and reinstalling the capscrew through
the control lever and forward slot (C). Repeat with the
other ground speed lever.
\
Figure 34. Control
Lever Adjustment
A. Jam Nut
B. Carriage
Bolt
C. Forward Slot
D. Mount Bolts
E. Knob
SPEED BALANCING
ADJUSTMENT
If the rider veers to the right or left when the ground
speed control levers are in the maximum forward posi-
tion, the top speed of the right lever can be balanced by
turning the adjustment knob (E, Figure 34). Loosen the
jam nut and turn the knob COUNTERCLOCKWISE
to
increase speed or CLOCKWISE to decrease speed.
Tighten the jam nut when complete.
28

Publicidad

Tabla de contenido
loading

Tabla de contenido