Compliance And Conformity; Conectores De Interfaz; Canadian Department Of Communications Compliance Statement - Triumph Adler P-4030D Manual De Instrucciones

Compliance and Conformity

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• The use of a non-shielded interface cable with the referenced device is prohibited.
—
CAUTION The changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This device complies with Part 15 of FCC Rules.
Operation is subject to the following two conditions; (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
* The above warning is valid only in the United States of America.

Conectores de interfaz

IMPORTANTE Asegúrese de apagar la impresora antes de conectar o desconectar un cable de interfaz. Para pre-
venir descargas electrostáticas que pueden afectar a la electrónica interna de la impresora a través del conector o
conectores de interfaz, cubra los conectores de interfaz que no utilice con la tapa protectora suministrada.
Nota Utilice cables de interfaz blindados.

Canadian Department of Communications Compliance Statement

This Class B digital apparatus complies with Canadian ICES-003.
Avis de conformité aux normes du ministère des Communications du
Canada
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
vii